Installation Guide
Table Of Contents
- Cellular 500W Module Remote Installation Guide
- Contents
- New in This Document
- 1 Important Safety and Compliance Information
- 2 About the Itron Cellular 500W Module
- 3 Initializing and Connecting
- 4 Installing the Cellular 500W Remote Module
- 5 Completing Gel-cap Connections Using the Itron Splice Kit
- 6 Using the Itron Cable Armor
- 7 Troubleshooting
4. A connector is crimped properly when the top of the movable yellow center (1) is flush with
the top of the connector body (2).
Warning! Crimping the connector forces some sealant out of connector. The
sealant protects the inside of the connector against insects, moisture, and other
contaminants. The sealant may cause minor eye and skin irritation. Avoid eye
contact. Avoid prolonged or repeated skin contact. Contact Itron Support for
Safety Data Sheets (SDS).
5. After the Cellular 500W remote module to register or meter wire connections are completed,
arrange the connectors in a single file.
Cellular 500W Module Remote Installation Guide 5 Completing Gel-cap Connections Using the Itron Splice Kit
10 March 2021 815-0618-00 REV 000 Itron, Inc. Page 39 of 43