Installation Guide
Table Of Contents
- Cellular 500W Module Remote Installation Guide
- Contents
- New in This Document
- 1 Important Safety and Compliance Information
- 2 About the Itron Cellular 500W Module
- 3 Initializing and Connecting
- 4 Installing the Cellular 500W Remote Module
- 5 Completing Gel-cap Connections Using the Itron Splice Kit
- 6 Using the Itron Cable Armor
- 7 Troubleshooting
4. To wire the Cellular 500W remote module to the RTR 2-wire register, connect the Cellular
500W remote module wires to the 2-wire register using gel-cap connectors. After the wires
are connected, carefully tuck the connectors into the Cellular 500W remote module housing.
5. Place the Cellular 500W remote module on the register, ensuring that the edge of the
Cellular 500W remote module housing is seated properly around the perimeter of the
register as shown.
Note: A gasket is not required.
6. Install four Torx-head mounting screws (SCR-0010-005) and hand-tighten the screws.
Cellular 500W Module Remote Installation Guide 4 Installing the Cellular 500W Remote Module
10 March 2021 815-0618-00 REV 000 Itron, Inc. Page 35 of 43