Installation Guide
Table Of Contents
- Cellular 500W Module Remote Installation Guide
- Contents
- New in This Document
- 1 Important Safety and Compliance Information
- 2 About the Itron Cellular 500W Module
- 3 Initializing and Connecting
- 4 Installing the Cellular 500W Remote Module
- 5 Completing Gel-cap Connections Using the Itron Splice Kit
- 6 Using the Itron Cable Armor
- 7 Troubleshooting
1. The Cellular 500W remote module has three wires that connect to the register:
1 brown insulated wire
2 yellow insulated wire
3 gray insulated wire
Note: For an RTR register, tuck the unused yellow wire into the housing.
2. Connect the Cellular 500W remote module wires to the register using gel-cap connectors
following the Cellular 500W remote module to the Badger ADE register wire connections
(see Encoder-type Register Connections on page 16).
3. After the wires are connected, carefully tuck the connectors into the Cellular 500W remote
module housing.
Cellular 500W Module Remote Installation Guide 4 Installing the Cellular 500W Remote Module
10 March 2021 815-0618-00 REV 000 Itron, Inc. Page 34 of 43