Installation Guide
Table Of Contents
- Cellular 500W Module Remote Installation Guide
- Contents
- New in This Document
- 1 Important Safety and Compliance Information
- 2 About the Itron Cellular 500W Module
- 3 Initializing and Connecting
- 4 Installing the Cellular 500W Remote Module
- 5 Completing Gel-cap Connections Using the Itron Splice Kit
- 6 Using the Itron Cable Armor
- 7 Troubleshooting
Completing the SET Valve Wire Connections
Connect the Cellular 500W remote module wires to the SET valve wires following the
connections shown in the SET Valve/Cellular 500W remote module wire connections table.
SET valve to Cellular 500W remote module wiring
Remote module wire color Blue Orange Purple/white
SET shutoff valve wire color Green Red Black
Remote Mount Installation
Connect the Cellular 500W remote module to the register as described in Initializing and
Connecting on page 15.
Using a back plate, create a template by drilling through a back plate lug slot to mark the position
of the screw. Use the drilled back plate as your mounting template.
The arrow on the Cellular 500W remote module must point up when installation is complete.
Installing on a Flat Surface
1. Select an installation location.
2. Using a back plate template, drill three pilot holes into the wall or other surface. The two
bottom holes should be level.
3. Screw a mounting screw for the lug slot into the surface, leaving approximately 1/8-inch of
the screw protruding. The lug slot should slide over the screw with a tight fit.
Cellular 500W Module Remote Installation Guide 4 Installing the Cellular 500W Remote Module
10 March 2021 815-0618-00 REV 000 Itron, Inc. Page 29 of 43