Installation Guide
Table Of Contents
- Cellular 500W Module Remote Installation Guide
- Contents
- New in This Document
- 1 Important Safety and Compliance Information
- 2 About the Itron Cellular 500W Module
- 3 Initializing and Connecting
- 4 Installing the Cellular 500W Remote Module
- 5 Completing Gel-cap Connections Using the Itron Splice Kit
- 6 Using the Itron Cable Armor
- 7 Troubleshooting
5. Completely tighten all screws evenly in an alternating fashion.
Pipe Mount Installation
The Cellular 500W remote module can mount on a pipe vertically, diagonally, or horizontally
using a pipe mount kit and remote mount kit (see Mounting Accessories on page 20).
Mounting the Pipe Bracket on a Vertical Pipe
Caution: A vertical mounting position is important to maximize RF performance.
Mount the module with the module's label arrow pointing up. The module's arrow must
never point to either side or upside down. The module's tilt tamper functionality is
designed to operate with the module installed vertically.
1. Remove the pipe bracket and band clamp from the pipe mount kit (Itron part number CFG-
0005-003). Pipe brackets may be black or gray. These instructions show a black pipe
bracket.
Cellular 500W Module Remote Installation Guide 4 Installing the Cellular 500W Remote Module
10 March 2021 815-0618-00 REV 000 Itron, Inc. Page 25 of 43