Installation Guide
Table Of Contents
- Cellular 500W Module Remote Installation Guide
- Contents
- New in This Document
- 1 Important Safety and Compliance Information
- 2 About the Itron Cellular 500W Module
- 3 Initializing and Connecting
- 4 Installing the Cellular 500W Remote Module
- 5 Completing Gel-cap Connections Using the Itron Splice Kit
- 6 Using the Itron Cable Armor
- 7 Troubleshooting
Installing the Backplate
After the connections are made to the register and optional telemetry device, attach the Cellular
500W remote module's backplate.
Mount the remote module after the backplate is attached.
Attaching the Backplate
1. Route the register cable and telemetry device cable through the dual-port backplate. Ensure
that the cable strain reliefs are inside the module housing and backplate assembly.
2. Route the register cable through the bottom backplate cable cutout and telemetry device
cable through the top backplate cable cutout.
Cellular 500W Module Remote Installation Guide 4 Installing the Cellular 500W Remote Module
10 March 2021 815-0618-00 REV 000 Itron, Inc. Page 23 of 43