Installation Guide
Table Of Contents
- Cellular 500W Module Remote Installation Guide
- Contents
- New in This Document
- 1 Important Safety and Compliance Information
- 2 About the Itron Cellular 500W Module
- 3 Initializing and Connecting
- 4 Installing the Cellular 500W Remote Module
- 5 Completing Gel-cap Connections Using the Itron Splice Kit
- 6 Using the Itron Cable Armor
- 7 Troubleshooting
2. Insert the pointed end of the cable tie into the receptacle end of the cable tie with the ribbed
edge facing in.
3. Pull the pointed end of the cable tie until the cable tie is hand-tightened.
4. Insert the excess cable tie into the cable tie gun. Pull the cable gun trigger to tighten and clip
the excess cable tie. The cable tie gun shown in the illustration is equipped with a red dial that
allows the user to set the cable tightening pressure of the cable gun.
Note: If your cable tie gun is equipped with a dial to set the tightening pressure, set the
pressure to ensure that the cable tie is secure on the lead wire. After installation, the
cable tie must not move on the register or secondary lead wire.
5. If your cable tie gun does not have a clipping feature, remove the cable tie from the cable tie
gun. Using a side cutter pliers, clip the excess cable tie.
6. Place the cable connection into the Cellular 500W remote module housing with the cable ties
to the inside.
Cellular 500W Module Remote Installation Guide 4 Installing the Cellular 500W Remote Module
10 March 2021 815-0618-00 REV 000 Itron, Inc. Page 22 of 43