Installation Guide
Table Of Contents
- Cellular 500W Module Pit Installation Guide
- Contents
- New in This Document
- 1 Important Safety and Compliance Information
- 2 About the Itron Cellular 500W Module
- 3 Installing the Cellular 500W Pit Module
- 4 Initializing, Connecting, and Programming the Pit Module
- 5 Using the Itron Cable Armor
- 6 Connecting the Inline Connector
- 7 Completing Gel-cap Connections Using the Itron Splice Kit
- A Troubleshooting
6. Insert the connectors and wires into the splice tube until the connectors and wires are
completely immersed in the non-conductive gel material.
7. Separate the cable wires to the sides and close the splice tube cover.
8. Remove any leftover materials from the customer premises.
Cellular 500W Module Pit Installation Guide 7 Completing Gel-cap Connections Using the Itron Splice Kit
09 March 2021 815-0617-00 REV000 Itron, Inc. Page 40 of 41