Installation Guide
Table Of Contents
- Cellular 500W Module Pit Installation Guide
- Contents
- New in This Document
- 1 Important Safety and Compliance Information
- 2 About the Itron Cellular 500W Module
- 3 Installing the Cellular 500W Pit Module
- 4 Initializing, Connecting, and Programming the Pit Module
- 5 Using the Itron Cable Armor
- 6 Connecting the Inline Connector
- 7 Completing Gel-cap Connections Using the Itron Splice Kit
- A Troubleshooting
4. Install the security seal as shown. Push it until it snaps into place.
For future meter or pit module servicing, break the security seal by pulling the seal apart. The
original protective connector caps can be reused if kept clean and dry. Install a new security
seal after servicing either device. To order replacement security seals, see the Water
Products Ordering Guide (PUB-0063-001). Environmental caps employ multiple seals to
protect the connector from the environment. Environmental cap design allows utilities to
install the pit module and, at a future date, install a OLS.
Caution: Shield connectors with protective environmental caps (for more
information, see Pit Module Mounting Accessories on page 16). Do not leave an
exposed connector in the field.
Cellular 500W Module Pit Installation Guide 6 Connecting the Inline Connector
09 March 2021 815-0617-00 REV000 Itron, Inc. Page 37 of 41