Installation Guide
Table Of Contents
- Cellular 500W Module Pit Installation Guide
- Contents
- New in This Document
- 1 Important Safety and Compliance Information
- 2 About the Itron Cellular 500W Module
- 3 Installing the Cellular 500W Pit Module
- 4 Initializing, Connecting, and Programming the Pit Module
- 5 Using the Itron Cable Armor
- 6 Connecting the Inline Connector
- 7 Completing Gel-cap Connections Using the Itron Splice Kit
- A Troubleshooting
6
Connecting the Inline Connector
Note: If an inline connector is not used or the pit module is already connected to the water
meter or register, skip this step.
1. Remove the protective environmental cap from the module connector.
Caution: Verify that the connector ends are clean and dry before assembly.
If any of the following conditions occur, do not install the modules.
–
Any of the three pins are damaged or missing.
–
The O-ring is missing.
–
The cable is cut or nicked.
2. Remove the protective cap from the register or accessory connector.
3. Connect the register cable to the pit module connector.
–
Align the connectors.
–
Push until snug.
–
Twist the register cable's black coupling nut to align the two tabs.
09 March 2021 815-0617-00 REV000 Itron, Inc. Page 36 of 41