Installation Guide
Table Of Contents
- Cellular 500W Module Pit Installation Guide
- Contents
- New in This Document
- 1 Important Safety and Compliance Information
- 2 About the Itron Cellular 500W Module
- 3 Installing the Cellular 500W Pit Module
- 4 Initializing, Connecting, and Programming the Pit Module
- 5 Using the Itron Cable Armor
- 6 Connecting the Inline Connector
- 7 Completing Gel-cap Connections Using the Itron Splice Kit
- A Troubleshooting
Verifying Operation
Use one of the following handheld computers to verify consumption:
■
FC300SR handheld computer
■
Itron Mobile Radio connected to a user-supplied computer or Bluetooth device
Caution: Verifying the Cellular 500W Pit Module operation requires an
FC300SR handheld computer or Itron Mobile Radio running FDM v4.0 or higher.
Legacy Itron handheld programming devices cannot read the pit modules.
■
Each handheld radio requires special setup and configuration parameters to successfully
read and program the pit module. Refer to the respective meter reading application for
specific instructions.
■
When comparing the actual register value to that reported by the pit module, please keep in
mind the Cellular 500W module's consumption value is updated once an hour when it is in
Run Mode.
1
This wire and associated information is not applicable for two port versions of the Cellular
500W module.
2
This wire and associated information is not applicable for two port versions of the Cellular
500W module.
Cellular 500W Module Pit Installation Guide 4 Initializing, Connecting, and Programming the Pit Module
09 March 2021 815-0617-00 REV000 Itron, Inc. Page 32 of 41