Installation Guide
Table Of Contents
- Cellular 500W Module Pit Installation Guide
- Contents
- New in This Document
- 1 Important Safety and Compliance Information
- 2 About the Itron Cellular 500W Module
- 3 Installing the Cellular 500W Pit Module
- 4 Initializing, Connecting, and Programming the Pit Module
- 5 Using the Itron Cable Armor
- 6 Connecting the Inline Connector
- 7 Completing Gel-cap Connections Using the Itron Splice Kit
- A Troubleshooting
Pit module wire color
Red (data)
1
Black (power/clock) White (ground)
Register manufacturer Register screw terminal
Mag8000CT-7ME6820
Mag8000-7ME6810
Zenner (Hendey) ETR Green Red Black
Pulser-type Register Connections
Pit module connections are made by the meter manufacturer for pulser-type registers. This
information describes those connections.
Caution: Itron recommends OpenWay Riva pit module connections be completed
using the inline connector. In rare instances, if a spliced connection is made, the Itron
splice kit must be used (Itron part number OEM-0034-002). For more information, see
Completing Gel-cap Connections Using the Itron Splice Kit on page 38
Module wire color
Red
2
Black White
Register manufacturer Register screw color designator
Badger RTR (3-wire) Red Black Green
Badger RTR (2-wire) Red Black No connection
Badger M5000 Mag Meter Red terminal: Out 1+ Black terminal: Out 1- White terminal: Out 1+
Cadillac Meter CMAG/EMAG
Magnetic Flow
DO1/DO2 COM DO1/DO2
Elster Digital Black Green Red
Elster V100T Black Red Blue
■ Itron (Actaris)
■ Flostar (2-wire)
■ Cyble Sensor
Either wire Remaining wire must be connected to both ERT
module wires
Krohne IFC Term B Term H Term B
RG3 Tomahawk Green Black Green
Sensus PMM Red Black Bare
Cellular 500W Module Pit Installation Guide 4 Initializing, Connecting, and Programming the Pit Module
09 March 2021 815-0617-00 REV000 Itron, Inc. Page 31 of 41