Installation Guide
Table Of Contents
- Cellular 500W Module Pit Installation Guide
- Contents
- New in This Document
- 1 Important Safety and Compliance Information
- 2 About the Itron Cellular 500W Module
- 3 Installing the Cellular 500W Pit Module
- 4 Initializing, Connecting, and Programming the Pit Module
- 5 Using the Itron Cable Armor
- 6 Connecting the Inline Connector
- 7 Completing Gel-cap Connections Using the Itron Splice Kit
- A Troubleshooting
Caution: Do not force the connector ends together. While you hold the
disconnect valve's connector, engage the pit module's connector by rotating the
locking ring until both connectors are securely connected. Twist only the connector
locking ring, not the body of the connector. Twisting the connector body could
damage the pit module and disconnect valve's connector pins.
Install an Itron security seal through the aligned security holes.
Cellular 500W Module Pit Installation Guide 3 Installing the Cellular 500W Pit Module
09 March 2021 815-0617-00 REV000 Itron, Inc. Page 27 of 41