Installation Guide
Table Of Contents
- Cellular 500W Module Pit Installation Guide
- Contents
- New in This Document
- 1 Important Safety and Compliance Information
- 2 About the Itron Cellular 500W Module
- 3 Installing the Cellular 500W Pit Module
- 4 Initializing, Connecting, and Programming the Pit Module
- 5 Using the Itron Cable Armor
- 6 Connecting the Inline Connector
- 7 Completing Gel-cap Connections Using the Itron Splice Kit
- A Troubleshooting
2. From the bottom side of the lid, screw on the threaded retainer clip collar until the beveled top
rests against the pit lid.
Note: Ensure that the beveled edge of the clip collar is toward the top of the pit lid.
3. Align and insert the retainer clip tab (1) into the retainer clip receptacle (2) on the pit module
housing.
Verify that the clip locks into place and the retainer clip collar is hand-tightened against the pit lid.
Caution: Carefully align the pit module through lid assembly. If the assembly is
improperly aligned, the pit lid may not close.
Cellular 500W Module Pit Installation Guide 3 Installing the Cellular 500W Pit Module
09 March 2021 815-0617-00 REV000 Itron, Inc. Page 19 of 41