Installation Guide
Table Of Contents
- Cellular 500G Module Remote Installation Guide
- Contents
- New in This Document
- 1 Important Safety and Compliance Information
- U.S. and Canadian Patent Numbers
- USA, FCC Part 15 Spectrum Compliance
- Modifications, Repairs, Installation, and Removal
- Canada, ISED Spectrum Compliance
- RF Exposure (FCC/ISED)
- Transportation Classification
- Lithium Battery Safety
- Equipment Repairs
- Intrinsic Safety
- Electrostatic Ignition Hazard
- Module Cleaning
- Do Not Drop
- 2 About the Itron Cellular 500G Remote Module
- 3 Mounting
- 4 Programming
- 5 Specific Meter Manufacturer Installation
- 6 Diaphragm Meter Installation
- 7 Using Gel-cap Connectors to Complete Wiring Connections
- 8 Optional Sealant Application Instructions
8
Optional Sealant Application Instructions
In areas where insect intrusion is a problem, Itron recommends an optional sealant to help keep
insects out of the module housing. The Itron-tested and approved sealant (Itron part number
ADH-5106-000) is used to seal gaps in remote module installations that can allow insect
intrusion.
1. Prepare the module for the sealant by verifying the application
area is clean and dry.
Warning! Apply sealant in a well-
ventilated area.
2. Itron recommends sealant application after the remote module
is installed so the cable is in the installation position. Use the
sealant (ADH-5106-000) to fill the gap.
3. Use enough sealant to fill the gap. Wipe off any excess sealant
and replace the cover on the sealant tube.
10 March 2021 815-0622-00 REV 000 Itron, Inc. Page 91 of 91