Installation Guide
Table Of Contents
- Cellular 500G Module Remote Installation Guide
- Contents
- New in This Document
- 1 Important Safety and Compliance Information
- U.S. and Canadian Patent Numbers
- USA, FCC Part 15 Spectrum Compliance
- Modifications, Repairs, Installation, and Removal
- Canada, ISED Spectrum Compliance
- RF Exposure (FCC/ISED)
- Transportation Classification
- Lithium Battery Safety
- Equipment Repairs
- Intrinsic Safety
- Electrostatic Ignition Hazard
- Module Cleaning
- Do Not Drop
- 2 About the Itron Cellular 500G Remote Module
- 3 Mounting
- 4 Programming
- 5 Specific Meter Manufacturer Installation
- 6 Diaphragm Meter Installation
- 7 Using Gel-cap Connectors to Complete Wiring Connections
- 8 Optional Sealant Application Instructions
Programming and Requirements Notes for Diaphragm
Meter Installations
For remote module programming, see Programming on page 21.
Residential ModuleProgramming Notes
The module is programmed based on the meter's drive rate. Take note of the index drive rate
shown on a lower dial on the index. Elster American meter index drive rates are either 1-cubic
foot, 2-cubic feet or 0.05 cubic meters (not shown below).
Commercial ModuleProgramming Notes
Take note of the index drive rate shown on the index. The is programmed based on the drive
rate. Elster American commercial meter index drive rates may be 5-, 10- or 100 cubic feet. The
index shown has a 10-cubic foot drive rate.
Cellular 500G Module Remote Installation Guide 6 Diaphragm Meter Installation
10 March 2021 815-0622-00 REV 000 Itron, Inc. Page 88 of 91