Installation Guide
Table Of Contents
- Cellular 500G Module Remote Installation Guide
- Contents
- New in This Document
- 1 Important Safety and Compliance Information
- U.S. and Canadian Patent Numbers
- USA, FCC Part 15 Spectrum Compliance
- Modifications, Repairs, Installation, and Removal
- Canada, ISED Spectrum Compliance
- RF Exposure (FCC/ISED)
- Transportation Classification
- Lithium Battery Safety
- Equipment Repairs
- Intrinsic Safety
- Electrostatic Ignition Hazard
- Module Cleaning
- Do Not Drop
- 2 About the Itron Cellular 500G Remote Module
- 3 Mounting
- 4 Programming
- 5 Specific Meter Manufacturer Installation
- 6 Diaphragm Meter Installation
- 7 Using Gel-cap Connectors to Complete Wiring Connections
- 8 Optional Sealant Application Instructions
Romet ECM2 to remote module mounting option
2. Insert the mounting screw fitted with the three lock
washers. Two lock washers are used as spacers (as
shown).
3. Attach the mounting plate to the meter. Insert the
mounting screw where the module screw was
removed. Torque the mounting screw to 5-7 ft.lbs. to
secure the plate to the Romet meter.
4. Mount the remote module using the pre-drilled holes on the mounting plate and the module mounting
screws.
5. Place new tamper seals over the two screws. Press tamper seals into place using an 11/32-inch nut driver
or similar blunt tool.
6. Connect the module to the meter using the
previously installed cable interface.
Romet Mechanical and Wiring Installation Instructions
These instructions describe installation with Romet cables and setup options for the AdEM
corrector and ECM2 meter. These instructions include the two most common setup
configurations. For specialized setup instructions, contact Romet.
Cellular 500G Module Remote Installation Guide 5 Specific Meter Manufacturer Installation
10 March 2021 815-0622-00 REV 000 Itron, Inc. Page 69 of 91