Installation Guide
Table Of Contents
- Cellular 500G Module Remote Installation Guide
- Contents
- New in This Document
- 1 Important Safety and Compliance Information
- U.S. and Canadian Patent Numbers
- USA, FCC Part 15 Spectrum Compliance
- Modifications, Repairs, Installation, and Removal
- Canada, ISED Spectrum Compliance
- RF Exposure (FCC/ISED)
- Transportation Classification
- Lithium Battery Safety
- Equipment Repairs
- Intrinsic Safety
- Electrostatic Ignition Hazard
- Module Cleaning
- Do Not Drop
- 2 About the Itron Cellular 500G Remote Module
- 3 Mounting
- 4 Programming
- 5 Specific Meter Manufacturer Installation
- 6 Diaphragm Meter Installation
- 7 Using Gel-cap Connectors to Complete Wiring Connections
- 8 Optional Sealant Application Instructions
to ensure a secure fit.
c. Install the two bottom screws in an alternating fashion.
8. Mount the module for uncorrected pulse outputs on the right bracket mounting space.
a. Insert three #8-32 x 1/2-inch screws in a triangular pattern.
Install the top screw so the head of the screw is approximately 1/8-inch from the
mounting bracket surface.
b. Slide the module onto the screw so the mounting lug fits securely onto the screw. If
necessary, remove the module and make any necessary adjustment to the screw depth
to ensure a secure fit.
c. Install the two bottom screws in an alternating fashion.
9. Route the module cables under the bracket edge and toward the rear of the Honeywell
Instrument.
10. Mount the mounting bracket (Honeywell Instrument part number 22-1077, included in the kit)
onto the Mini-Max enclosure.
a. Place a #8 metal flat washer followed by a rubber sealing washer onto both #8-32 x 3/8-
inch screws.
b. Align the lower threaded holes in the mounting bracket with the drilled enclosure holes
and insert a screw/washer through the enclosure housing. Screws heads must be inside
the enclosure.
c. Tighten both screws using a screwdriver.
Note: Aligning the second bracket threaded hole and drilled hole may require some
manipulation of the mounting bracket.
11. Insert the module cables (both units) through the large cable strain relief on the left rear of
the instrument's enclosure. Leave a one-half to one inch drip loop under the cable strain
relief.
12. Secure three cable ties on the module cables in three places on the cables as specified by
information included in the kit.
13. Re-install the input switchboard, main board, and battery pack removed in step 2.
Honeywell Mechanical and Wiring Installation Instructions
This section includes the information to wire two modules to a single Honeywell Instrument.
Installation requires the correct programming parameters (for programming parameters, see
Programming on page 21).
Cellular 500G Module Remote Installation Guide 5 Specific Meter Manufacturer Installation
10 March 2021 815-0622-00 REV 000 Itron, Inc. Page 57 of 91