Installation Guide

Honeywell Product Mounting Instructions
Two Remote Modules Mounted On a Honeywell Mini-Max Instrument
1. Place the Honeywell Instrument volume corrector in shutdown condition and disconnect all
power from the Mini-Max main board.
2. Remove the battery pack from the volume corrector and set it aside.
3. Remove the four screws from the main board and the board from the enclosure. Set the
board aside.
4. Remove the two hex screws from the input switchboard and the switchboard from the
enclosure and set it aside. You will re-install the switchboard later.
Warning! The battery pack, main board, and switchboard may be damaged if left
in the Honeywell Instrument volume corrector while completing this installation.
5. Drill two 3/16-inch holes in the back of the Mini-Max enclosure as specified by the information
included in the kit. Remove any metal shavings from the enclosure.
6. Clean the remote modules with the alcohol wipe where you will place the corrected and
uncorrected labels (included in the kit).
Note: Clean the modules with the alcohol wipe to ensure good label adhesion.
7. Mount the module for corrected pulse outputs on the left bracket mounting space.
a. Insert three #8-32 x 1/2-inch screws in a triangular pattern.
Install the top screw so the head of the screw is approximately 1/8-inch from the
mounting bracket surface.
b. Slide the module onto the screw so the mounting lug fits securely onto the screw. If
necessary, remove the module and make any necessary adjustment to the screw depth
Cellular 500G Module Remote Installation Guide 5 Specific Meter Manufacturer Installation
10 March 2021 815-0622-00 REV 000 Itron, Inc. Page 56 of 91