Installation Guide

Wiring for direct connection to the IMC/W2
3. After completing the wiring connections, install a
cable tie to the meter cable just below the exposed
colored lead wires on the cable insulation. Remove
the excess cable tie using a hand-held side-cutter
pliers. The cable tie performs as a cable strain relief
to mitigate the risk of destructive tension on the lead
wires.
4. Tuck the three gel connectors and cable tie inside the module housing, as shown in the placement
illustration and schematic.
5. Install the remote module backplate using the four screws previously removed from the module and a Torx
T-10 screwdriver.
6. Plug the cable into the pulse output of the index.
Important! Verify that the cable tie and gel connectors are inside the module
housing and that the cable extends out of the backplate slot. Torque the
backplate mounting screws 9 to 12 inch-pounds.
7. Mount the module as required for your application.
Wall and pipe mount options are described in
Mounting on page 16. Additional options for GE
specific mounting solutions are described in the
product specific mounting instructions in this GE Oil
and Gas section.
Cellular 500G Module Remote Installation Guide 5 Specific Meter Manufacturer Installation
10 March 2021 815-0622-00 REV 000 Itron, Inc. Page 52 of 91