Installation Guide

Table Of Contents

6. Attach the brackets to the meter using the

previously removed screws.

7. Splice the meter pulse output wires to the module wires using gel cap connectors. Follow the wire

connections for the D800/D1000 to module wire connections below.

Note: Use a crimping tool compatible with gel-connectors. Details on using the

crimping tool are included in the mounting installation section of this document.

D800/D1000 meter module

Pulse output Wire Pulse output 1 Pulse output 2 Pulse output 1

with fault

Pulse output 2

with fault

Output 1+ Brown White and blue White

Output 1- Green Red Red

Output 2+ White White and blue White

Output 2- Black Red Red

Output 3+ Red White White

Output 3- Blue Blue Blue

8. Install a cable tie strain relief on the cable

approximately 1/8" from the end of the cable

insulation.

9. Position the cable so the strain relief is just inside

the slot on the module's backplate.

Cellular 500G Module Remote Installation Guide 5 Specific Meter Manufacturer Installation

10 March 2021 815-0622-00 REV 000 Itron, Inc. Page 48 of 91