Installation Guide
Table Of Contents
- Cellular 500G Module Remote Installation Guide
- Contents
- New in This Document
- 1 Important Safety and Compliance Information
- U.S. and Canadian Patent Numbers
- USA, FCC Part 15 Spectrum Compliance
- Modifications, Repairs, Installation, and Removal
- Canada, ISED Spectrum Compliance
- RF Exposure (FCC/ISED)
- Transportation Classification
- Lithium Battery Safety
- Equipment Repairs
- Intrinsic Safety
- Electrostatic Ignition Hazard
- Module Cleaning
- Do Not Drop
- 2 About the Itron Cellular 500G Remote Module
- 3 Mounting
- 4 Programming
- 5 Specific Meter Manufacturer Installation
- 6 Diaphragm Meter Installation
- 7 Using Gel-cap Connectors to Complete Wiring Connections
- 8 Optional Sealant Application Instructions
12. Twist the remote module's blue and white wires together.
13. Connect the twisted blue and white wires to terminal 2
on the K1 terminal port.
Eagle Research Corrector Programming and Requirements Notes
Important! This information is subject to change without notice. Refer to the Eagle
Research product documentation to verify the most current programming and
configuration information for the 500G remote module.
Using Itron remote modules with Eagle Research volume correctors requires Eagle Research
Field Manager software configured with the parameters for your model of Eagle Research
corrector.
Using Eagle Research Field Manager to Change the MPplus Settings
1. Open the Eagle Research Field Manager from the
Start menu or the desktop shortcut.
2. Connect the communications cable from your computer into the MS connector on the side of the MPplus
corrector. After the MS connector is connected, take note of the baud rate displayed on the front of the
corrector.
3. Click Connect on the upper left corner of the Field
Manager window.
Cellular 500G Module Remote Installation Guide 5 Specific Meter Manufacturer Installation
10 March 2021 815-0622-00 REV 000 Itron, Inc. Page 31 of 91