Installation Guide
Table Of Contents
- Cellular 500G Module Remote Installation Guide
- Contents
- New in This Document
- 1 Important Safety and Compliance Information
- U.S. and Canadian Patent Numbers
- USA, FCC Part 15 Spectrum Compliance
- Modifications, Repairs, Installation, and Removal
- Canada, ISED Spectrum Compliance
- RF Exposure (FCC/ISED)
- Transportation Classification
- Lithium Battery Safety
- Equipment Repairs
- Intrinsic Safety
- Electrostatic Ignition Hazard
- Module Cleaning
- Do Not Drop
- 2 About the Itron Cellular 500G Remote Module
- 3 Mounting
- 4 Programming
- 5 Specific Meter Manufacturer Installation
- 6 Diaphragm Meter Installation
- 7 Using Gel-cap Connectors to Complete Wiring Connections
- 8 Optional Sealant Application Instructions
1. Verify that you have the correct programming mode (OpenWay Riva Network Mode or
Mobile Mode [mobile high power mode, mobile/handheld mode, or hard-to-read mode]) for
your application.
2. For all programming and Check Endpoint operations using a handheld computer, hold the
handheld as close to vertical as possible. For best success, keep the handheld within six feet
of the target module.
3. Programming parameters are based on the configuration file loaded into the programming
device.
4. Read or Check the remote module using a compatible handheld computer.
–
If the read result is higher than the number programmed in step 1, the module is counting
correctly.
–
If the read result is not higher than the number programmed in step 1, replace the remote
module.
Itron Programs and Software Variables
This section defines and clarifies possible system variables you may encounter in programming
modules.
Field Deployment Manager (FDM)
The following tables illustrate various FDM programming configurations and the endpoint
response to each setting.
Cellular 500G Module Remote Installation Guide 4 Programming
10 March 2021 815-0622-00 REV 000 Itron, Inc. Page 22 of 91