Installation Guide
Table Of Contents
- Cellular 500G Module Remote Installation Guide
- Contents
- New in This Document
- 1 Important Safety and Compliance Information
- U.S. and Canadian Patent Numbers
- USA, FCC Part 15 Spectrum Compliance
- Modifications, Repairs, Installation, and Removal
- Canada, ISED Spectrum Compliance
- RF Exposure (FCC/ISED)
- Transportation Classification
- Lithium Battery Safety
- Equipment Repairs
- Intrinsic Safety
- Electrostatic Ignition Hazard
- Module Cleaning
- Do Not Drop
- 2 About the Itron Cellular 500G Remote Module
- 3 Mounting
- 4 Programming
- 5 Specific Meter Manufacturer Installation
- 6 Diaphragm Meter Installation
- 7 Using Gel-cap Connectors to Complete Wiring Connections
- 8 Optional Sealant Application Instructions
1. Drill three pilot holes in the mounting surface. The drilled
pilot holes for the two bottom screws must be on a horizontal
line.
a. 3 inches
b. 1-11/16 inches
c. 3-3/8 inches
2. Screw the top mounting screw into the top pilot hole drilled in
step one, leaving enough of the screw protruding so the module
lug recess on the back plate slides over the screw head and fits
completely into the lug recess. Make adjustments as necessary.
3. Install the two bottom mounting screws. Tighten the screws in an alternating pattern to secure the module
firmly in position.
4. Place a new tamper seal over each bottom module mounting
screw as required.
Note: To reduce the risk of cable damage,
secure any excess module cabling with a
cable tie.
Cellular 500G Module Remote Installation Guide 3 Mounting
10 March 2021 815-0622-00 REV 000 Itron, Inc. Page 20 of 91