Installation Guide
Table Of Contents
- Cellular 500G Module Remote Installation Guide
- Contents
- New in This Document
- 1 Important Safety and Compliance Information
- U.S. and Canadian Patent Numbers
- USA, FCC Part 15 Spectrum Compliance
- Modifications, Repairs, Installation, and Removal
- Canada, ISED Spectrum Compliance
- RF Exposure (FCC/ISED)
- Transportation Classification
- Lithium Battery Safety
- Equipment Repairs
- Intrinsic Safety
- Electrostatic Ignition Hazard
- Module Cleaning
- Do Not Drop
- 2 About the Itron Cellular 500G Remote Module
- 3 Mounting
- 4 Programming
- 5 Specific Meter Manufacturer Installation
- 6 Diaphragm Meter Installation
- 7 Using Gel-cap Connectors to Complete Wiring Connections
- 8 Optional Sealant Application Instructions
10. Insert the tamper seals.
11. Gather the excess module cabling into a loop and
use the cable tie to secure the gathered cable to the pipe.
Adapter Plate Mounting Positions
Note: The notch at the top of the adapter plate (1) must always be at the top position. The
following illustrations show the various mounting configurations. The adapter plate mounting
screw locations are indicated (2).
45-degree angle with the pipe
running to the right
45-degree angle with the pipe running to
the left
Horizontal
Selecting and Installing On a Wall or Flat Vertical
Mounting Location
Carefully select a mounting location free from electrical wires. The mounting location must have
the proper clearance to accommodate the 1-1/2-inch module mounting screws so nothing is
damaged by the drill or mounting screws. Use a compatible mounting screw.
Cellular 500G Module Remote Installation Guide 3 Mounting
10 March 2021 815-0622-00 REV 000 Itron, Inc. Page 19 of 91