Installation Guide

Important! Modules ordered pre-programmed with security injected and specified as
Zero Touch Deployment require that the installer rotates the wriggler five (5) times to
activate the module to join the network, if the module is installed in a location with little
or no gas flow.
Functional Specifications
Functional
specification
Description
Power source Single "D" cell lithium batteries
Tamper detection Tilt and cut cable
Regulatory and
Standards
FCC compliance: Part 15.247, 15.249 (programming)
FCC IDs:
■ EWQ500GA: American/Rockwell
■ EWQ500GB: Sprague/Itron
■ EWQ500GC: Commercial
■ EWQ500GR: Remote
ISED compliance: RSS-247, RSS-210 (programming)
IC:
■ 864D-500GA: Amercian/Rockwell
■ 864D-500GB: Sprague/Itron
■ 864D-500GC: Commercial
■ 864D-500GR: Remote
Measurement Canada: Pending
Intrinsically safe
per
Telemetering Equipment for use in Hazardous Locations, for Cl I, Div 1, Gp D for Haz
Loc, Temp Code T1, -40°C ≤ Ta ≤ +70°C.
Operational All 500G modules operate without the need for an FCC or ISED license.
Frequency: 902 to 928 MHz ISM band
Program frequency: 908 MHz
Australia ACMA AS/NZS 4268
Frequency: 915 to 928 MHz ISM band
Program frequency: 916 to 926.8 MHz
Product
identification
Numeric and bar coded type and serial number
Construction
materials
Gray polycarbonate housing and back plate with encapsulated electronics
Cellular 500G Module Remote Installation Guide 2 About the Itron Cellular 500GRemote Module
10 March 2021 815-0622-00 REV 000 Itron, Inc. Page 14 of 91