Installation Guide

GAS Micro wiring connections
GAS Micro corrector P13 connection 100G Module wires
Pulse output2-E C3
Pulse output2-C C4
Programming Notes
For more information about programming the Galvanic Gas Micro Electronic volume
corrector, see the GAS MICRO Operator’s Manual, Galvanic part number MA1956. Contact
Galvanic Applied Sciences, Inc. to obtain the operator’s manual.
GE Oil and Gas Meter Installation
This section provides the instructions to install the Cellular 500G on the following compatible
GE Oil and Gas meters.
Meter model Meter notes Itron part
number
Module notes
D800/D1000
Pulse width must be
set greater than 100
mS.
Firmware version
must be 1.71 or
higher.
ERG-7000-503
ERG-7000-505
Both modules are
compatible with
these meter
models.
B3 Series pulse output meter
LMMA pulse output meter
Rotary meters
equipped with Weigh
and Wire solid state
pulsers. Meter must
have factory-
installed pulsar with
connector output.
Purchase correct
cable interface from
GE Dresser. Pulser
must be version 17
or higher.
ERG-7000-503
Integral Micro Corrector IMC/W2
Electronic volume
corrector for Series A
(LMMA) and Series
B (rotary meters).
Must be meter
firmware version
1.94 or earlier. Pulse
width must be set for
125 ms.
ERG-7000-505
Cellular 500G Module Remote Mount Installation Guide 4 Specific Meter Manufacturer Installation
October 11, 2021 815-0622-00 REV 000 Itron, Inc. Page 51 of 99
DRAFT