Installation Guide
Table Of Contents
- Cellular 500W Remote Module Installation Guide
- Contents
- New in This Document
- 1 Introduction
- 2 Initialization, Connection, and Programming
- 3 Setup and Installation
- 4 Completing Gel-cap Connections Using the Itron Splice Tube Kit
- 5 Troubleshooting
- 6 Important Safety and Compliance Information
3. Wrap the entire piece of electrical tape around the Cellular 500W cable near the Cellular
500W .
4. Beginning over the installed electrical tape, twist the Itron cable armor onto the Cellular
500W cable using a right-handed twist.
Important! You must twist—not wrap—the cable armor onto the Cellular 500W
cable. Wrapping the cable armor can cause the stainless steel jacket to warp.
You must begin twisting the cable armorover the portion of the cable protected
by the electrical tape. If you do twist the cable armor onto the Cellular 500W
cable on the unprotected portion of the Cellular 500W cable, you could damage
the module's cable. A cut cable could cause a Cellular 500W or register
communication failure.
5. Continue to twist the cable armor onto the Cellular 500W cable until the cable armor
covers the entire cable.
6. Remove any leftover materials from the customer premises. Discard or recycle leftover
materials.
Cellular 500W Remote Module Installation Guide 3 Setup and Installation
October 11, 2021 815-0618-00 REV 000 Itron, Inc. Page 37 of 44
DRAFT