Installation Guide
Table Of Contents
- Cellular 500W Remote Module Installation Guide
- Contents
- New in This Document
- 1 Introduction
- 2 Initialization, Connection, and Programming
- 3 Setup and Installation
- 4 Completing Gel-cap Connections Using the Itron Splice Tube Kit
- 5 Troubleshooting
- 6 Important Safety and Compliance Information
The remote module automatically detects the presence of connected water disconnect
devices within 22.5 minutes and begins reading disconnect valve data. To immediately detect
the water disconnect valve and begin reading data, perform a Check with a handheld
computer running FDM software.
The Remote Disconnect Valve connects to the Cellular 500W orange, blue, and purple/white
wires.
Wire Connections
Connect the Cellular 500W wires to the Remote Disconnect Valve wires following the
connections shown in the table below.
Remote Disconnect Valve to Cellular 500W wiring
Remote module wire color Blue Orange Purple/white
SET shutoff valve wire color Green Red Black
Leak Sensor Installation
Installation of the Leak Sensor with a Cellular 500W requires an Leak Sensor with flying lead
ends (LDS-1601-002). For the remote module installation instructions, see OpenWay
®
Riva
Leak Sensor Installation Guide.
Itron Cable Armor Installation
The Itron cable armor provides a layer or protection for the module's cable jacket. Itron cable
armor is available in five-foot sections.
This section describes the procedure for installing Itron cable armor in a field installation.
Cellular 500W Remote Module Installation Guide 3 Setup and Installation
October 11, 2021 815-0618-00 REV 000 Itron, Inc. Page 34 of 44
DRAFT