Installation Guide
Table Of Contents
- Cellular 500W Remote Module Installation Guide
- Contents
- New in This Document
- 1 Introduction
- 2 Initialization, Connection, and Programming
- 3 Setup and Installation
- 4 Completing Gel-cap Connections Using the Itron Splice Tube Kit
- 5 Troubleshooting
- 6 Important Safety and Compliance Information
6. Insert a tamper seal over each mounting screw and drive into place with a nut driver or a
similar tool.
Note: A tamper seal is fully seated when the top of the tamper seal is approximately
1/16 inches below the top of the screw recess.
7. Secure any excess cable using the provided cable ties.
Remote Disconnect Valve Installation
This section describes installation of a Smart Earth Technologies (SET)Remote Disconnect
Valve in an OpenWay water system. The Cellular 500W supports the following states.
■
Connected. The water flow is open and flowing at 100% configured capacity.
■
Disconnected. The water flow is shut off with no water flowing. The remote water
disconnect valve provides the ability to remotely open (reconnect) the valve.
■
Restricted. The water is restricted and flowing at the configured installation flow.
Cellular 500W Remote Module Installation Guide 3 Setup and Installation
October 11, 2021 815-0618-00 REV 000 Itron, Inc. Page 33 of 44
DRAFT