Installation Guide
Table Of Contents
- Cellular 500W Remote Module Installation Guide
- Contents
- New in This Document
- 1 Introduction
- 2 Initialization, Connection, and Programming
- 3 Setup and Installation
- 4 Completing Gel-cap Connections Using the Itron Splice Tube Kit
- 5 Troubleshooting
- 6 Important Safety and Compliance Information
2. Using a back plate, create a template by drilling through a back plate lug slot to mark the
position of the screw. Use the drilled back plate as your mounting template.
The arrow on the Cellular 500W must point up when installation is complete.
To install on a flat surface
1. Select an installation location.
2. Using a back plate template, drill three pilot holes into the wall or other surface. The two
bottom holes should be level.
3. Screw a mounting screw for the lug slot into the surface, leaving approximately 1/8-inch of
the screw protruding. The lug slot should slide over the screw with a tight fit.
4. Slide the Cellular 500W lug slot onto the mounting screw, pushing the Cellular 500W
upward until the screw head is all the way into the slot.
5. Screw the Cellular 500W to the wall using the remaining two mounting screws.
Cellular 500W Remote Module Installation Guide 3 Setup and Installation
October 11, 2021 815-0618-00 REV 000 Itron, Inc. Page 32 of 44
DRAFT