Installation Guide
Table Of Contents
- Cellular 500W Remote Module Installation Guide
- Contents
- New in This Document
- 1 Introduction
- 2 Initialization, Connection, and Programming
- 3 Setup and Installation
- 4 Completing Gel-cap Connections Using the Itron Splice Tube Kit
- 5 Troubleshooting
- 6 Important Safety and Compliance Information
To mount on the adapter plate
1. Locate the two 1 inch Cellular 500W mounting screws in the pipe mount kit.
2. Slide the Cellular 500W back cover onto the adapter, pushing up to secure the lug adapter
in the lug slot.
3. Install the two 1 inch Cellular 500W mounting screws.
4. Tighten the screws to 9 to 12 inch-pounds of torque.
Remote Mount Installation
1. Connect the Cellular 500W to the register as described in Initialization, Connection,
and๎Programming on page 13.
Cellular 500W Remote Module Installation Guide 3 ๎Setup and Installation
October 11, 2021 815-0618-00 REV 000 Itron, Inc. Page 31 of 44
DRAFT