Installation Guide
Table Of Contents
- Cellular 500W Remote Module Installation Guide
- Contents
- New in This Document
- 1 Introduction
- 2 Initialization, Connection, and Programming
- 3 Setup and Installation
- 4 Completing Gel-cap Connections Using the Itron Splice Tube Kit
- 5 Troubleshooting
- 6 Important Safety and Compliance Information
5. Push the end of the band through the band clamp screw assembly. Turn the band clamp's
screw assembly to fit into the pipe bracket opening. Tighten the clamp screw until the band
clamp is secure on the pipe.
Adapter Plate Mounting Positions
The installation procedure in the previous section shows how to mount the adapter plate on a
vertical pipe.
The following pictures show the adapter plate on 45-degree angle and horizontal pipes.
Regardless of the angle of the pipe, the adapter plate mounting lug (1) must always be at the
top.
If the pipe is at a 45° angle up to the right, install the adapter plate with the mounting screws
(2) as shown.
If the pipe is at a 45° angle up to the left, install the adapter plate as shown.
If the pipe is horizontal, install the adapter plate as shown.
Cellular 500W Remote Module Installation Guide 3 Setup and Installation
October 11, 2021 815-0618-00 REV 000 Itron, Inc. Page 30 of 44
DRAFT