Installation Guide
Table Of Contents
- Cellular 500W Remote Module Installation Guide
- Contents
- New in This Document
- 1 Introduction
- 2 Initialization, Connection, and Programming
- 3 Setup and Installation
- 4 Completing Gel-cap Connections Using the Itron Splice Tube Kit
- 5 Troubleshooting
- 6 Important Safety and Compliance Information
Contents
Cellular500W Remote Module Installation Guide 1
Contents 3
New in This Document 5
1 Introduction 6
Related Documents 7
Security 8
Transmission Modes 8
Mobile Mode 8
Network Mode 8
Operating Modes 9
Battery Life 10
Low Battery 10
Events and Alarms 10
Extended Alarm Flag 10
Network Mode 11
Firmware Functionality 11
2 Initialization, Connection, andProgramming 13
Programming 13
Encoder-type Register Connections 14
Pulser-type Register Connections 16
Cable Extension 16
Operation Verification 16
3 Setup and Installation 18
Module Cable Strain Relief Installation 18
To Install the Cable Strain Relief 18
Backplate Installation 20
Attaching the Backplate 20
Cellular 500W Installation 22
Mounting Accessories 23
Direct-mount to the Meter Register 23
Pipe Mount Installation 29
October 11, 2021 815-0618-00 REV 000 Itron, Inc. Page 3 of 44
DRAFT