Installation Guide
Table Of Contents
- Cellular 500W Remote Module Installation Guide
- Contents
- New in This Document
- 1 Introduction
- 2 Initialization, Connection, and Programming
- 3 Setup and Installation
- 4 Completing Gel-cap Connections Using the Itron Splice Tube Kit
- 5 Troubleshooting
- 6 Important Safety and Compliance Information
4. To wire the Cellular 500W to the RTR two wire register, connect the Cellular 500W wires to
the two wire register using gel-cap connectors. After the wires are connected, carefully
tuck the connectors into the Cellular 500W housing.
5. Place the Cellular 500W on the register, ensuring that the edge of the Cellular 500W
housing is seated properly around the perimeter of the register as shown.
Note: A gasket is not required.
6. Install four Torx-head mounting screws (SCR-0010-005) and hand-tighten the screws.
Cellular 500W Remote Module Installation Guide 3 Setup and Installation
October 11, 2021 815-0618-00 REV 000 Itron, Inc. Page 27 of 44
DRAFT