Installation Guide
Table Of Contents
- Cellular 500W Remote Module Installation Guide
- Contents
- New in This Document
- 1 Introduction
- 2 Initialization, Connection, and Programming
- 3 Setup and Installation
- 4 Completing Gel-cap Connections Using the Itron Splice Tube Kit
- 5 Troubleshooting
- 6 Important Safety and Compliance Information
1. The Cellular 500W has three wires that connect to the register:
2. Connect the Cellular 500W wires to the register using gel-cap connectors following the
Cellular 500W to the Badger ADE register wire connections (see Encoder-type Register
Connections on page 14).
3. After the wires are connected, carefully tuck the connectors into the Cellular 500W
housing.
Cellular 500W Remote Module Installation Guide 3 Setup and Installation
October 11, 2021 815-0618-00 REV 000 Itron, Inc. Page 26 of 44
DRAFT