Installation Guide
Table Of Contents
- Cellular 500W Remote Module Installation Guide
- Contents
- New in This Document
- 1 Introduction
- 2 Initialization, Connection, and Programming
- 3 Setup and Installation
- 4 Completing Gel-cap Connections Using the Itron Splice Tube Kit
- 5 Troubleshooting
- 6 Important Safety and Compliance Information
5. If your cable tie gun is equipped with a dial to set the tightening pressure, set the pressure
to ensure that the cable tie is secure on the lead wire. After installation, the cable tie must
not move on the register or secondary lead wire.
6. If your cable tie gun does not have a clipping feature, remove the cable tie from the cable
tie gun. Using a side cutter pliers, clip the excess cable tie.
7. Place the cable connection into the Cellular 500W housing with the cable ties to the inside.
Cellular 500W Remote Module Installation Guide 3 Setup and Installation
October 11, 2021 815-0618-00 REV 000 Itron, Inc. Page 19 of 44
DRAFT