Installation Guide
Table Of Contents
- Cellular 500W Remote Module Installation Guide
- Contents
- New in This Document
- 1 Introduction
- 2 Initialization, Connection, and Programming
- 3 Setup and Installation
- 4 Completing Gel-cap Connections Using the Itron Splice Tube Kit
- 5 Troubleshooting
- 6 Important Safety and Compliance Information
โ
FC300SR handheld computer
โ
Itron Mobile Radio connected to a user-supplied computer or Bluetooth device
Caution: Verifying the Cellular 500W operation requires an FC300SR handheld
computer or Itron Mobile Radio running FDM v4.0 or higher. Legacy Itron handheld
programming devices cannot read the Cellular 500W .
Each handheld radio requires special setup and configuration parameters to successfully read
and program remote modules. Refer to the respective meter reading application for specific
instructions.
When comparing the actual register value to that reported by the Cellular 500W, please keep
in mind the Cellular 500W 's consumption value is updated once an hour when it is in Run
Mode.
Cellular 500W Remote Module Installation Guide 2 ๎Initialization, Connection, and๎Programming
October 11, 2021 815-0618-00 REV 000 Itron, Inc. Page 17 of 44
DRAFT