Installation Guide
Table Of Contents
- Cellular 500W Module Pit Installation Guide
- Contents
- New in This Document
- 1 Introduction
- 2 Initialization, Connection, and Programming
- 3 Cellular 500W Pit Module Installation
- 4 Accessory Installation
- 5 Completing Gel-cap Connections Using the Itron Splice Kit
- A Troubleshooting
- B Important Safety and Compliance Information
4. Beginning over the installed electrical tape, twist the Itron cable armor onto the pit module
cable using a right-handed twist.
Important! You must twist—not wrap—the cable armor onto the pit module
cable. Wrapping the cable armor can cause the stainless steel jacket to warp.
You must begin twisting the cable armor over portion of the cable protected by
the electrical tape. If you do not begin to twist the cable armor over the protected
portion of the pit module cable, a cut cable could cause an pit module/register
communication failure.
5. Continue to twist the cable armor onto the pit module cable until the cable armor covers
the entire cable.
6. Remove any leftover materials from the customer premises. Discard or recycle leftover
materials.
Cellular 500W Module Pit Installation Guide 4 Accessory Installation
October 13, 2021 815-0617-00 REV000 Itron, Inc. Page 32 of 40
DRAFT