Installation Guide

Caution: Carefully align the pit module through lid assembly. If the assembly is
improperly aligned, the pit lid may not close.
Pit lid mounting installation is complete.
Rod Mount Installation
Important! Rod mount installation requires the rod mount adapter. For more
information, see Mounting Accessories on page 19.
500W ERT Pit Modules can mount below the pit lid on a customer-supplied 0.5 inch diameter
rod. A mounting rod is available from Itron. For more information, see the 500W Module
Ordering Guide.
Caution:Consider the following when installing the pit module on a rod mount:
■ The rod installation area must be free from other pipes, wires, or facilities that may be damaged by
driving a rod into the ground.
■ You must follow local codes when using the rod mount installation method.
■ Failure to use a 0.5 inch rod and follow instructions may result in an unreliable installation.
■ Pit module positioning other than upright will negatively affect radio performance.
Required Tools and Hardware
The following tools are required for rod mount installation.
■
Hammer
■
0.5 inch outside diameter rod (you may use either a square or round rod)*
■
Tape measure
■
Rod-driving tool (optional)
■
Rod cutting tool
Cellular 500W Module Pit Installation Guide 3 Cellular 500W Pit Module Installation
October 13, 2021 815-0617-00 REV000 Itron, Inc. Page 22 of 40
DRAFT