User's Manual
Table Of Contents
- Before You Begin
- Introduction
- 2.4ZR OpenWay Range Extender Configuration and Installation
- Configuration and Installation Checklist
- Required Configuration Tools
- 2.4ZR OpenWay Range Extender Configuration Overview
- Configuring the 2.4ZR OpenWay Range Extender
- Reconfiguring or Reading an Installed 2.4ZR OpenWay Range Extender
- Selecting a Mounting Location
- Linking to a CENTRON Meter
- Linking to a 2.4GZ OpenWay Gas Module
- Installing the 2.4ZR OpenWay Range Extender
- Troubleshooting
Installing the 2.4ZR OpenWay Range Extender
TDC-0832-001 2.4ZR OpenWay® Range Extender Installation Guide 16
Proprietary and Confidential
To install tamper seals
1. Place a tamper seal (included with the range extender) over each range extender mounting screw.
2. Push the tamper seals into place with a 1/4-inch nut driver or similar blunt tool.
Note A tamper seal is fully seated when the top of the tamper seal is approximately 1/16-inch below the
top of the screw recess.
3. Record the range extender location according to your company asset management requirements.