User's Manual
Table Of Contents
- Before You Begin
- Introduction
- 2.4ZR OpenWay Range Extender Configuration and Installation
- Configuration and Installation Checklist
- Required Configuration Tools
- 2.4ZR OpenWay Range Extender Configuration Overview
- Configuring the 2.4ZR OpenWay Range Extender
- Reconfiguring or Reading an Installed 2.4ZR OpenWay Range Extender
- Selecting a Mounting Location
- Linking to a CENTRON Meter
- Linking to a 2.4GZ OpenWay Gas Module
- Installing the 2.4ZR OpenWay Range Extender
- Troubleshooting
Installing the 2.4ZR OpenWay Range Extender
TDC-0832-001 2.4ZR OpenWay® Range Extender Installation Guide 15
Proprietary and Confidential
2. Turn a mounting screw for the range extender mounting lug part way into the mounting surface.
3. Place the 2.4ZR mounting lug recess (at the top of the range extender's backplate) just under the screw
head. Slide the range extender upward until the screw head fits completely inside the mounting lug recess.
Several adjustments may be necessary to properly position the screw.
4. Install the two bottom mounting screws. Fasten screws in an alternating fashion until fully tightened to
secure the range extender firmly in position.
Caution Do not over-tighten the range extender mounting screws. Over-tightening the mounting screws
may damage the range extender's polycarbonate case.