User's Manual

TDC-0832-001 2.4ZR OpenWay® Range Extender Installation Guide 14
Proprietary and Confidential
Note Perform each procedure in the order listed in the Configuration and Installation Checklist on
page 5.
The 2.4ZR OpenWay Range Extender includes three mounting screws and two tamper seals. To permanently
mount the range extender, perform the following procedure.
To mount the 2.4ZR OpenWay Range Extender
1. If the permanent mounting location is significantly different from the location first attempted, perform the
procedures Linking to a CENTRON Meter on page 11 and Linking to a 2.4GZ OpenWay Gas Module on
page 12 again to verify the radio links are satisfactory for the permanent mounting location.
Note For easier installation, you may drill three pilot holes in the mounting surface (use the 1/8-inch drill
bit to accommodate the range extender mounting screws, see the Drilling Template). Carefully select a
mounting location free from electrical wires. The mounting location must have the proper clearance to
accommodate the #10 x 1-1/2-inch mounting screws so nothing is damaged by the drill or mounting
screws.
When drilling pilot holes to mount the 2.4ZR OpenWay Range Extender, the two bottom screw holes
must be on a horizontal line. If the range extender will mount on a sheet metal surface, use the mounting
screws included. Use a comparable wood screw to mount the range extender on a vertical wood surface.
2.4ZR OpenWay Range Extender Drilling Template
A. 3-inches
B. 1-11/16-inches
C. 3-3/8-inches
C H A P T E R 3
Installing the 2.4ZR OpenWay Range Extender