User's Manual

2.4ZR OpenWay Range Extender Configuration and Installation
TDC-0832-001 2.4ZR OpenWay® Range Extender Installation Guide 8
Proprietary and Confidential
To configure the 2.4ZR OpenWay Range Extender
1. Position and hold the Itron magnet over the label barcode on the range extender for approximately five
seconds. Remove the magnet.
2. Watch the blink pattern of both LEDs to verify the range extender is searching for the configuration
devices. The range extender should now be exchanging data with the handheld computer running
Endpoint-Link or FDM software. Magnet swipes while the range extender is in field configuration mode
are ignored.
LED
Number of
Blinks
Description
Both
3
The range extender is scanning for available networks.
Both
5
Join to handheld network is complete.
When the 2.4ZR OpenWay Range Extender successfully joins a handheld network, it scans for a
communication from the handheld. If no communication is heard within 30 seconds, the range extender
leaves the handheld network.
3. Using the handheld loaded with Endpoint-Link or FDM, verify successful range extender configuration.
Important If the 2.4GZ OpenWay gas module is not programmed, it must be programmed at this time.
Refer to the 2.4GZ OpenWay Gas Module Installation Guide - Direct Mount (TDC-0816) or 2.4GZ
OpenWay Gas Module Installation Guide- Remote Mount (TDC-0838) for complete instructions.