User's Manual Part 2

Diaphragm Meter Installation
TDC-0838-001 2.4GZ OpenWay Gas Module Installation Guide - Remote Mount 63
Proprietary and Confidential
9. Press the magnet hub down over the hub spacer as far as possible. The bottom of the hub spacer may
touch the index face. Turn the dial after magnet hub installation to verify the index dial functions with a
smooth, easy rotation.
10. If the tip of the dial needle sticks out past the edge of the magnet hub, cut off the end of the dial needle as
close as possible to the magnet hub with a sharp, side-cutting pliers.
11. Take the acetone stick applicator from the Remote Encoder Installation Kit (Itron part number CFG-0081-
001).
12. Select a location on the index face next to the magnet hub. After encoder installation, the encoder cable
must not interfere with the index dials.