User's Manual Part 1

Electronic Instrument Installation

TDC-0838-001 2.4GZ OpenWay Gas Module Installation Guide - Remote Mount 46

Proprietary and Confidential

To make TCI pulse connections

Note Connect one endpoint/channel to the alarm output if the endpoints are used on channels A and B.

Configuration for two endpoints connected to one TCI

Channel A

OWG-500x-504

TCI

White

Orange and brown

Red

Yellow

Blue

Blue (alarm)

Channel B

OWG-500x-504

TCI

White

Red

Green

Blue

White

1. Remove strain relief fitting by unscrewing from the gray adapter plate.

Note Do not remove the fitting's hex nut. Un-screw the entire fitting from the gray adapter plate. A tether

line is secured to the strain relief fitting. When the strain relief fitting is removed, the tether line pulls the

unterminated wires out of the adapter plate for access to the loose wires.

2. Loosen the strain relief fitting hex nut and remove the white plug from the center.

3. Place the strain relief fitting onto the field pulse cable.