User's Manual Part 1

Electronic Instrument Installation
TDC-0838-001 2.4GZ OpenWay Gas Module Installation Guide - Remote Mount 40
Proprietary and Confidential
Wiring the 2.4GZ OpenWay Remote Mount Gas Module to the
Mercury Instrument
Use the Terminal strip connector (Phoenix connector) in the Mercury Instrument to connect the 2.4GZ
OpenWay remote mount gas module to the instrument.
Note In Mercury Instrument EC-AT correctors, the connector may be soldered to the pulse
board.
The 2.4GZ OpenWay remote mount gas module has three lead wires (red, white, and blue). The red wire is
attached according to Mercury Instrument Code Settings (see Code Settings on page 38).
The blue and white wires are twisted together and attached according to Mercury Instrument's Code Settings
(see Code Settings on page 38).