User's Manual Part 1

Rotary Meter Installation

TDC-0838-001 2.4GZ OpenWay Gas Module Installation Guide - Remote Mount 21

Proprietary and Confidential

To connect the 2.4GZ OpenWay remote mount gas module to the rotary meter cable

1. Remove the backplate (4 screws) from the 2.4GZ OpenWay Remote and expose the module's lead

wires. The backplate and screws will be re-installed on the gas module later in this procedure so store

them (temporarily) in a safe, secure place.

2. Insert the lead wires from the 2.4GZ OpenWay remote mount gas module into new 3M gel connectors

(Itron part number CON-0023-001) together with the same colored lead wire from the meter cable (see

the wiring table below) and crimp using a 3M hand-held crimping tool.

Note Do not strip lead wire prior to inserting the wire in the gel connector.

Rotary Meter to Remote Module Wire Table

Rotary Meter Wire

Remote module wire

Red

White

Blue