User's Manual Part 1

Mounting the 2.4GZ OpenWay Remote Mount Gas Module
TDC-0838-001 2.4GZ OpenWay Gas Module Installation Guide - Remote Mount 17
Proprietary and Confidential
1. Using the three 1-1/2-inch mounting screws from the Remote Mount Installation Kit, turn the mounting
screw for the mounting lug (top of endpoint) part way into the mounting surface.
2. Place the 2.4GZ OpenWay remote mount gas module mounting lug recess (on the top of the endpoint
backplate) just under the screw head. Slide the endpoint upward until the screw head fits completely inside
the mounting lug recess. Several adjustments may be necessary to properly position the screw for endpoint
mounting.
3. Install the bottom two mounting screws. Fasten screws in an alternating fashion until fully tightened to
secure the endpoint firmly in position.
To install tamper seals and cable ties
1. Place a new tamper seal (from the Remote Mount Installation Kit) over each endpoint mounting screw.
2. Firmly push both tamper seals into place with a 1/4-inch nut driver or similar blunt tool.
Note A tamper seal is fully seated when the top of the tamper seal is approximately 1/16 inch below the
top of the screw recess.