User's Manual Part 1

Mounting the 2.4GZ OpenWay Remote Mount Gas Module
TDC-0838-001 2.4GZ OpenWay Gas Module Installation Guide - Remote Mount 15
Proprietary and Confidential
To install tamper seals and cable ties
1. Ensure the label arrow points up or down (1). Place the new tamper seals from the Remote Mount
Installation Kit over the 2.4GZ OpenWay remote mount gas module mounting screws (2, 3). Firmly push
both tamper seals all the way into place with a 1/4-inch nut driver or similar blunt tool.
Note A tamper seal is fully seated when the top of the tamper seal is approximately 1/16-inch below the
top of the screw recess.
2. Gather any excess endpoint cable. Loop a cable tie around the pipe and excess endpoint cable.
3. Insert the chiseled end of the cable tie into the locking end and pull the cable tie tight. Cut off and properly
dispose the excess cable tie.
2.4GZ OpenWay remote mount gas module pipe mount installation is complete.